콘테스트 등록

I need some Graphic Design

진행 현황: Closed
상금: $50
응모작 접수(건수): 5
수상자: smarkies

Winner

콘테스트 개요

So we need to design a holder for our sensors in solidworks preferably

this holder should look similar to the lamb post (attached) that will be hanged on, exactly attached at the middle of the post , it should extend to 125 , with three degrees of freedom , one for the sensor plate at the end to have different angles from the vertical view say 90 degrees, 45 degrees and 30 degrees from the y axis,
and another for the solar panel holder next to the edge of the sensor so it can go to any direction along the horizontal axis , and also the last degree of freedom is for the length of the holder that could start from 125 to 160 cm

I will be attaching some holders we have done before that would inspire u , and the holder that need to design for the decorated one attached as .bmp file

but we need something that will look cool and similar to the post design so it doesn't look so weird or intriguing

in your design , you need to show the sensor attached to the holder design , as well as the solar panel and its connections

the sensor box is attached (it is 210x150x90 mm)

the thickness of the holder should not exceed 10 cm in length and you could use rectangular shape

이 콘테스트의 최상위 응모작

smarkies Ireland

1
NewlyEDU China

0

공개 설명 게시판

콘테스트 주최자
- 5 년 전
manually is fine for now Makhan S.
- 5 년 전
makhan22
- 5 년 전
hello Mustafa, you guys are doing an amazing job against flood, so you want to control the degree of freedom manually Or via any other mechanism like the electric motor?
- 5 년 전
콘테스트 주최자
- 5 년 전
it is ok, but prefer solidworks
- 5 년 전
smarkies
- 5 년 전
Is it ok to use other modeling software? like sketchup, still provide accurate measurements.
- 5 년 전