Longlight Firmware
$30-250 USD
착불
Hardware description
Light source: 1 or 2 ledstrip SK6812 (similar WS2812) with individually adressable leds.
Ledstrip can be RGB, RGBW or WWA (wharm white and amber)
Length 1 m (144 leds) or custom specified
Microprocessor control board: Teensy LC or alternative
Resistive touch strip with two channels, connected to analog inputs of Teensy.
Touch strip has same length as ledstrip.
At each end of the touch-strip is a separate switch (zone of 20mm) with separate voltage output. Pressing it sends >2v signal to Teensy.
Power supply 5 volt 20A
Mechanical: Lens and led protection, profile, strip and support
Firmware description
The Teensy LC can be programmed as an Arduino compatible board, using Teensyduino installer. [login to view URL]
Libraries for driving LEDs use FastLed and FastLed RGBW
The code can be tested during Skype and Teamviewer sessions, step by step development of code is suggested. It is not necessary to build hardware.
프로젝트 ID: #17186829
프로젝트 소개
이 일자리에 대한 프리랜서 10 명의 평균 입찰가: $201
Hi, I have both worked with WS2812 and SK6812 led strips. I used atmega328(Uno's mcu) and Nextion's LCD. It was spesific project for trucks I would like to share its videos over the chat. Yours Truly, Ali SERBETCI
Hi, I hope you are doing well. I have experience in LED based embedded project development. I have worked with WS2812B based LED strips. I have understood your requirements and would like to discuss the project f 기타
Hi, I am a professional electrical engineer. I am an expert in designing and simulating systems and writing arduino codes I also have the hardware to test and confirm working code. You can see some of my work in my por 기타
I am an experienced Arduino programmer and I have worked with Ws2812 addressable led strips before. Thanks for the consideration!
As long as Arduino is concerned, I can make it on it easily. I can also work on this alternative microprcessor.
