Hi.
Thanks for your posting.
I am an electronic engineer, having enough experience in IOT device, high speed circuit & PCB design.
I am sure I can support you with my skills.
Following is my skills and tools
- Electrical & electronic diagram, and schematic & PCB design.
• High circuit analysis and design such as DDR3, eMMC, 10Gbps Ethernet circuit
• RF Antenna/Front end, filter.
• Flexible PCB inlay design.
design(Up to 12 layers PCB design).
- Standardization and protocols
• FCC, ISO/IEC 14443, ISO/IEC 18092, ISO 18000
• ISO IEC 7816, ISO/IEC 7815
- Firmware development for any MCU.
• ARM Cortex Mxx, STM32xx, ATSAME70, AT91SAM, STC.
• AVR: ATmega328, ATmega1280, ATmega2560, ATtiny43U, ATtiny85...
• PIC: PIC16, 18, 24, 32 series
• Raspberry Pi
• Arduino series: arduino Uno, Mega2560
• Standalone RF module such as Nordic series, WiFi(ESP32, ESP8266) , BLE, Zigbee, Xbee
Design Tools
- Altium Designer 18, Cadsoft Eagle PADs, OrCAD
- MPLAB X, Micro C, uKeil, STM32 workbench, AVR Studio. Arduino IDE
- C, C++.
I can give you a perfect project.
Best Regards.