create and design a 2-Layer PCB for LED Lighting
- 진행 현황: Closed
- 상금: $130
- 응모작 접수(건수): 11
- 수상자: sbarbarelli
콘테스트 개요
I am in need of a customized 2-layer Printed Circuit Board (PCB) design for a specific RGBCW type of LED light. The purpose of this scalable PCB is primarily for power distribution and component mounting, with a secondary focus on signal routing.
Detailed Requirements:
1. LED Light Functionality:
- The PCB will be specifically used for room lighting and for RGB
- the controller is on a separate pcb from the lights. Though you don't have to design
- Must include the capability to control brightness and color change of the LEDs.
- im looking at RGBCW type leds
- the 3 holes are at 1.9mm but the pcb need them to be 2.0mm, the centered hole is 2.4 but the pcb needs to be 2.5mm, the hole that is on the edge is wer the wire going to be located the hole is 2.4mm but the pcb needs to be 2.5mm
--The input power is about 12vdc but it can be as high as 15vdc
Freelancer Capabilities:
1. PCB Design Expertise:
- Proven experience with 2-layer PCB design.
- Knowledge of LED light circuit design would be a plus.
- done in fritzing or in kicad is a most!
- all the components needs to be available at pcbway if out of stock is fine
2. Technical Skills:
- Skilled in PCB design software.
- Understanding of power distribution and signal routing.
Deliverables:
A final working design of a 2-layer PCB for LED lighting with brightness control and color change capability. Time efficiency and adherence to the highest quality standards are critical. All the components needs to be on one side
추천된 기술
이 콘테스트의 최상위 응모작
-
sbarbarelli Argentina
-
freelancerjunaye Bangladesh
-
freelancerjunaye Bangladesh
-
jpbriz80 Spain
-
mithun08deb Bangladesh
-
triesl Indonesia
-
bhuvanabkp123 India
-
triesl Indonesia
-
sbarbarelli Argentina
-
triesl Indonesia
-
I-TECH Pakistan
공개 설명 게시판
콘테스트를 시작하는 방법
-
콘테스트 등록 신속하고 간편한 절차
-
응모작 접수 세계적인 참가 범위
-
최우수 응모작 선정 자료 파일의 다운로드(초간단!)